RADIANT & IN-FLOOR HEATING SERVICE IN NORTH LOUISIANA

It can be a great fit. Our winters are mild, and radiant heat delivers steady, gentle warmth without the blast-and-cool cycle of forced air — it's especially nice under the tile and concrete floors common in North Louisiana homes, which otherwise stay cool underfoot. It's popular for bathrooms, additions, sunrooms, and whole-home comfort.

Usually it's a zone problem: a stuck zone valve, air trapped in that loop, a thermostat fault, or an unbalanced manifold. A single cold zone rarely means the whole system is failing. We isolate the zone, bleed and balance it, and replace the valve or actuator if that's the cause.

The clearest sign on a hydronic system is pressure that keeps dropping and needs frequent topping up, sometimes with an unexplained damp spot on a slab or subfloor. We trace leaks without tearing up the whole floor and repair them at the source. Don't ignore a slow pressure drop — it only gets worse.

New in-floor radiant is quoted per zone, driven by the area, the floor construction (new slab, over subfloor, or under tile), and how many zones you want. The boiler or water heater that feeds the loop is quoted separately. We design the layout and give you a flat-rate number after a site visit.

A boiler or a dedicated water heater feeds the loop, with a circulator pump moving the warm water through the tubing and a manifold splitting it into zones. Because we handle both the heat source and the loop in-house, we can size and match them correctly instead of leaving you to coordinate two trades.

Hydronic radiant systems benefit from an annual check of pressure, the circulator, zone valves, and the heat source, plus bleeding any trapped air. It's low-maintenance overall, but a yearly look keeps the zones balanced and catches leaks early. We fold this into a seasonal heating tune-up.

Often yes, though it depends on the floor construction. In a remodel or addition we can lay tubing in a new slab, over a subfloor, or under certain floor coverings, and tie it into a boiler or water heater. On a site visit we'll tell you honestly what's practical for your home and quote it flat-rate before any work.

Yes. Electric radiant uses heating mats under tile and is common for a single bathroom or small area — simple, but more expensive to run over a large space. Hydronic (hot-water) radiant uses PEX loops fed by a boiler or water heater and is the better choice for whole rooms or a whole home. We service and install both and can tell you which fits your project.

We answer live 24/7 and dispatch quickly for a fast-dropping pressure or an active leak, usually on-site in 60 to 90 minutes for emergencies. Routine cold-zone and balancing calls are typically same-day or next-day. An after-hours surcharge applies on top of the repair.

The $189/year Service Savings Agreement Plan includes two HVAC tune-ups and an annual plumbing check-up, plus 15% off repairs and priority scheduling. For radiant-heated homes we tailor the heating tune-up to your system, and the 15% repair discount applies to radiant work — no auto-renew, cancel anytime.

Yes. Financing is available on radiant installs so a whole-home or multi-zone project doesn't have to be paid all at once. We'll go over the plans and monthly numbers with your flat-rate design quote so you can decide with the full picture in front of you.